| Step | | Procedure & Parts & Tools |
| 1 |
|
FILL THE RECOVERY TANK WITH WATER IF THE TANK IS EMPTY. REMOVE THE 3 SCREWS HOLDING THE POWER BOARD IN PLACE.
| Screwdriver-phillips |
|
|
| 2 |
|
PULL THE POWER BOARD DOWN AND REST ON STEP BOARD.
|
| 3 |
|
TURN THE KEY ON AND THE RED INDICATOR LIGHT THAT TANK IS FULL SHOULD BE LIT UP.
|
| 4 |
|
TURN THE KEY ON AND THE RED INDICATOR LIGHT THAT TANK IS FULL SHOULD BE LIT UP.
|
| 5 |
|
LOCATE THE BLACK TANK SENSOR WIRE AND DISCONNECT IT.
|
| 6 |
|
MAKE A JUMPER WITH A PAPERCLIP. INSERT BOTH ENDS OF THE PAPERCLIP INTO THE SENSOR WIRE PLUG.
|
| 7 |
|
MAKE SURE THE KEY IS ON AND TURN ON THE VAC MOTOR. STEP ON THE STEPBOARD. THE RED LIGHT WILL GO OUT. IF THE RED LIGHT GOES OUT, THE SENSOR IS OKAY. REVERSE STEPS 2 THRU 5 TO REASSEMBLE THE MACHINE.
|